Fault-Profile - Cisco NCS 1004 Command Reference Manual
Hide thumbs
Also See for NCS 1004:
- Hardware installation manual (70 pages) ,
- Manual (52 pages) ,
- Quick start manual (6 pages)
Table of Contents
Advertisement
Commands
fault-profile
Use the fault-profile command in the global configuration mode, to create a new fault profile with one or
more alarms and user-defined severity.
fault-profile name fault-identifier subsystem XR fault-type { ethernet | sdh_controller | sonet
| OPTICS | G709 } fault-tag name sas severity nsas severity
Syntax Description
fault-profile name
fault-identifier subsystem XR
fault-type
fault-tag name
sas severitynsas severity
No default behavior or values.
Command Default
Global Configuration
Command Modes
Command History
Release
Release
7.1.1
Name of the fault profile.
Supports the XR sub-system.
The component the fault profile is applicable to. The available options
are:
• ethernet
• sdh_controller
• sonet
• OPTICS
• G709
The faults that are included as part of the newly created fault profile.
Sets the severity level for:
• sas (service affecting; impacts traffic)
• nsas (non-service affecting; does not impact traffic)
The available options are:
• Critical
• Major
• Minor
• Non-faulted
• Non-reported
Modification
This command was introduced.
Command Reference for Cisco NCS 1004
fault-profile
25
- Quick Links:
- Controller Optics
Hide quick links:
Advertisement
Table of Contents
