Show Hw-Module - Cisco NCS 1004 Command Reference Manual
Hide thumbs
Also See for NCS 1004:
- Hardware installation manual (70 pages) ,
- Manual (52 pages) ,
- Quick start manual (6 pages)
Table of Contents
Advertisement
Commands
show hw-module
To display the details of the muxponder slice, Field Programmable Devices (FPDs), and the card configuration
in regen mode, use the show hw-module in XR EXEC or administration EXEC mode.
show hw-module { fpd | location location
regen
Syntax Description
fpd
location location
mxponder
mxponder-slice slicenumber
regen
None
Command Default
XR EXEC
Command Modes
Administration EXEC
Command History
Release
Release 7.0.1
Release 7.1.1
If the ISO image has new version of FPD, the Status column in show hw-module fpd command shows NEED
Usage Guidelines
UPGD. If the upgrade is required, use the upgrade hw-module location all fpd fpd_device_name command
to start the upgrade. When the upgrade starts, the Status column in show hw-module fpd command sequentially
shows UPGD PREP, UPGRADING, and the percentage of upgrade completion. After the upgrade is completed,
the Status column shows RLOAD REQ if the ISO image requires reload; otherwise the Status column shows
CURRENT.
Note
The upgrade of LC_OPT_MOD_FW FPD affects traffic. Hence, the user must perform this upgrade during
a maintenance window.
If reload is required:
If the FPGA location is 0/RP0, use the admin hw-module location 0/RP0 reload command. This command
reboots only the CPU. Hence, the traffic is not impacted. If the FPGA location is 0/0, use the admin hw-module
location all reload command. This command reboots NCS 1004. Hence, the traffic is impacted. After the
reload is completed, the new FPGA runs the current version.
] }
Displays the status of FPDs installed.
Specifies the location.
Displays information for all the slices of the muxponder.
Displays information for a specific slice of the muxponder. The valid values
of slicenumber are 0 and 1.
Displays information of card configuration in regen mode.
[ mxponder | mxponder-slice slicenumber |
Modification
This command was introduced.
regen keyword was added.
Command Reference for Cisco NCS 1004
show hw-module
87
- Quick Links:
- Controller Optics
Hide quick links:
Advertisement
Table of Contents
