Table of Contents
Advertisement
DLP- D223 Download an Alarm Severity Profile
Note
Step 6
Return to your originating procedure (NTP).
DLP-D223 Download an Alarm Severity Profile
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
To access the alarm profile editor from network view, click the Provisioning > Alarm Profiles tabs.
Step 1
To access the profile editor from node view, click the Provisioning > Alarm Profiles >
Step 2
Alarm Profile Editor tabs.
To access the profile editor from a card view, click the following tabs:
Step 3
•
•
•
Click Load.
Step 4
If you want to download a profile that exists on the node, click From Node in the Load Profile(s)
Step 5
dialog box.
a.
b.
If you want to download a profile that is stored locally or on a network drive, click From File in the
Step 6
Load Profile(s) dialog box.
a.
b.
c.
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-22
Reprovisioning an Ethernet port on the G-Series card does not reset the Ethernet statistics for
that port.
This task downloads a custom alarm severity profile from a network-drive
accessible CD-ROM, floppy disk, or hard disk location.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
If the card is an E-Series Ethernet, G-Series Ethernet, STM-N, or electrical (DS3i-N-12, E1-N-14,
E1-42, or E3-12) card, click the Provisioning > Alarm Profiles > Alarm Profile Editor tabs.
If the card is an ML-Series Ethernet (traffic) card, click the Provisioning > Ether Alarming >
Alarm Profile Editor tabs if you want to apply the profile to the front physical ports, or the
Provisioning > POS Alarming > Alarm Profile Editor tabs if you want to apply the profile to the
packet over SDH (POS) ports. For more information about ML-Series card ports and service, refer
to the Ethernet Card Software Feature and Configuration Guide for the Cisco ONS 15454,
Cisco ONS 15454 SDH, and Cisco ONS 15327.
If the card is an FC_MR-4 card, click the Provisioning > Alarm Profiles > Alarm Profile Editor
tabs.
Click the node name you are logged into in the Node Names list.
Click the name of the profile in the Profile Names list, such as Default.
Click Browse.
Navigate to the file location in the Open dialog box.
Click Open.
Chapter 19
DLPs D200 to D299
78-17194-01
Advertisement
Chapters
Table of Contents
