Table of Contents
Advertisement
Chapter 15
Maintain the Node
NTP-D108 Back Up the Database
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You must back up and restore the database for each node on a circuit path in order to maintain a complete
Note
circuit.
The following parameters are not backed up and restored: node name, IP address, subnet mask and
Note
gateway, and Internet Inter-ORB Protocol (IIOP) port. If you change the node name and then restore a
backed up database with a different node name, the circuits map to the new node name. Cisco
recommends keeping a record of the old and new node names.
Complete the
Step 1
are already logged in, proceed to
In node view, click the Maintenance > Database tabs.
Step 2
Click Backup.
Step 3
Save the database on the workstation's hard drive or on network storage. Use an appropriate file name
Step 4
with the .db file extension; for example, database.db.
Click Save.
Step 5
Click OK in the confirmation dialog box.
Step 6
Stop. You have completed this procedure.
78-17194-01
This procedure stores a backup version of the TCC2/TCC2P (software)
database on the workstation running Cisco Transport Controller (CTC)
or on a network server.
None
None
Required. Cisco recommends performing a database backup at
approximately weekly intervals and prior to and after configuration
changes.
Onsite or remote
Maintenance
"DLP-D60 Log into CTC" task on page 17-49
Step
2.
NTP- D108 Back Up the Database
at the node that you want to back up. If you
Cisco ONS 15454 SDH Procedure Guide, R7.0
15-5
Advertisement
Chapters
Table of Contents
