Table of Contents
Advertisement
DLP- D241 Clear an MS-SPRing Manual Ring Switch
From node or network view, click the Circuits > Rolls tabs.
Step 1
Click the rolled circuit that you want to cancel.
Step 2
Click Cancel.
Step 3
Return to your originating procedure (NTP).
Step 4
DLP-D241 Clear an MS-SPRing Manual Ring Switch
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1
From the View menu, choose Go to Network View.
Click the Provisioning > MS-SPRing tabs.
Step 2
Choose the MS-SPRing that the Manual ring switch that you want to clear and click Edit.
Step 3
To move an icon to a new location, for example, to see MS-SPRing channel (port) information more
Tip
clearly, click an icon on the Edit MS-SPRing network graphic and while pressing Ctrl, drag the icon to
a new location.
Right-click the MS-SPRing node channel (port) where the Manual ring switch was applied and choose
Step 4
Set West Protection Operation or Set East Protection Operation, as applicable.
In the dialog box, choose CLEAR from the drop-down list. Click OK.
Step 5
Click Yes in the Confirm MS-SPRing Operation dialog box. The letter "M" is removed from the channel
Step 6
(port) and the span turns green.
From the File menu, choose Close.
Step 7
Return to your originating procedure (NTP).
Step 8
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-44
This task clears a Manual ring switch.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Chapter 19
DLPs D200 to D299
78-17194-01
Advertisement
Chapters
Table of Contents
