Example: Setting Up Basic Device Parameters - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Chapter 4
Using the Configuration Manager
Example: Setting up Basic Device Parameters
78-13124-05
This example describes how to use the configuration manager to set the basic SSL
appliance configuration.
1.
Initiate a serial management session, and set the IP address of the device to
10.1.2.5.
SCA> enable
SCA# config
(config[CSS-SCA])# ip address 10.1.2.5 netmask 255.255.0.0
(config[CSS-SCA])#
2.
If you wish to configure the server using the serial connection, continue with
step 3.
If you wish to use a telnet connection, initiate a telnet session with the IP
address assigned in step 1, and go to step 3.
3.
Use the following commands to enter Privileged and Configuration modes
and change the name of the SSL appliance to myDevice.
SCA> enable
SCA# configure
(config[CS-10-1-2-3])# hostname myDevice
(config[CS-10-1-2-3])# end
SCA# configure
(config[myDevice])#
Set the default router.
4.
(config[myDevice])# ip route default 10.1.2.1
(config[myDevice])#
Set an enable password to protect the appliance configuration. The password
5.
is requested whenever the enable command is given.
Note
Passwords are not echoed to the screen.
(config[myDevice])# password enable
Enter new password:
Confirm password:
(config[myDevice])# end
SCAE
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Configuring the Device
4-7
Advertisement
Table of Contents
Troubleshooting
