Reverse-Proxy Server Configuration Command Set; Activate; Certgroup Serverauth - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Configuration Command Set
Reverse-Proxy Server Configuration Command Set
activate
Usage Guidelines
Related Commands
certgroup serverauth
Syntax Description
Cisco 11000 Series Secure Content Accelerator Configuration Guide
C-130
Use Reverse-Proxy Server Configuration commands to set up and configure
reverse-proxy servers. Enter Reverse-Proxy Server Configuration mode by using the
enable command in Non-Privileged mode, the configure command in Privileged
mode, the ssl command in Configuration mode, and the reverse-proxy-server
command in SSL Configuration mode. The prompt changes to
<config-ssl-rproxy[servername]>
Activates the current suspended reverse-proxy server if enough information has
been configured.
activate
Availability: Serial, Telnet; FIPS Mode (serial only)
All reverse-proxy servers are created as active servers by default.
suspend (Reverse-Proxy Server Configuration Command Set)
Assigns a certificate group to be used for server certificate authentication.
certgroup serverauth <certgroupname>
no certgroup serverauth
certgroupname
.
The name of the certificate group.
Appendix C
Command Summary
78-13124-05
Advertisement
Table of Contents
Troubleshooting
