Udld Message Time - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
54
1029
•
The errdisable recover reset command with the udld parameter to reset all
interfaces shut down by UDLD.
•
The errdisable recover cause with the udld parameter to automatically
recover from the UDLD error-disabled state.
Example
This example shows how to enable UDLD on all fiber interfaces:
switchxxxxxx(config)#
54.3 udld message time
Use the udld message time command in Global Configuration mode to configure a
global value of the interval between two sent probe messages. To return to the
default value, use the no form of this command.
Syntax
udld message time
seconds
no udld message time
Parameters
seconds
—Interval between two sent probe messages. The valid values are from
1 to 90 seconds.
Default Configuration
15 seconds.
Command Mode
Global Configuration mode
User Guidelines
Use this command to change the default value of the message interval - the
interval between two sequential sent probe messages.
udld normal
OL-32830-01 Command Line Interface Reference Guide
UDLD Commands
Advertisement
Table of Contents
