Enabling Udld Probe Message Interval; Recovering The Udld Protocol - Cisco NCS 4200 Series Configuration Manual
Lan switching
Hide thumbs
Also See for NCS 4200 Series:
- Configuration manual (87 pages) ,
- Configuration manuals (30 pages) ,
- Configuration manual (36 pages)
Table of Contents
Advertisement
Enabling UDLD Probe Message Interval
Enabling UDLD Probe Message Interval
SUMMARY STEPS
1. enable
2. configure terminal
3. udld message time interval
4. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
udld message time interval
Example:
Router(config)# udld message time 90
Step 4
end
Example:
Router# end
Recovering the UDLD Protocol
UDLD recovery when enabled, attempts to bring an UDLD error-disabled port out of reset. Tthe default
recovery timer is 300 seconds.
SUMMARY STEPS
1. enable
2. configure terminal
3. udld recovery inteval
4. end
LAN Switching Configuration Guide, Cisco IOS XE Everest 16.6.1 (Cisco NCS 4200 Series)
6
UniDirectional Link Detection (UDLD) Protocol
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
Enters global configuration mode.
Set the time in seconds between UDLD probe messages. The
valid range is from 7 to 90 seconds. The default is 15 seconds
Returns to privileged EXEC mode.
Advertisement
Table of Contents
