Identifying Sca Models; Connecting To Power; Table 2-2 Sca2 Port Led Descriptions - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Connecting to Power
Identifying SCA Models
Connecting to Power
Note
Cisco 11000 Series Secure Content Accelerator Configuration Guide
2-8
Table 2-2
SCA2 Port LED Descriptions
LED Name
Color
LNK
Green
ACT
Amber
100
Green
Test
Amber
SCA and SCA2 models can be differentiated by the text on the product label.
The Secure Content Accelerator is powered by dual AC power supplies. Before
you install the power cords, ensure that you have read Appendix A for electrical
specifications.
Ensure that the Secure Content Accelerator power switches are in the 0 (off)
1.
position.
Attach the power cables to the Secure Content Accelerator by plugging the
2.
AC power cord connector into the power receptacle at the rear panel.
Plug the power cords into dedicated three-wire grounding receptacles.
3.
Switch the power switches to the 1 (on) position.
4.
Connect the power supplies to different circuits to further ensure
appliance availability.
Chapter 2
Installing the Hardware and Software
State
Indication
Off
No link established
On
Link established
Blinking
Transmit activity detected
Off
10Mbps
On
100Mbps
Off
Self-diagnostics are successful
On
Self-diagnostics are running
78-13124-05
Advertisement
Table of Contents
Troubleshooting
