Env - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Command Set
Usage Guidelines
Examples
env
Cisco 11000 Series Secure Content Accelerator Configuration Guide
D-12
b
threeoctets
B
sixoctets
(This command must be entered on one line.)
The following example demonstrates setting the "Network" interface to 100Mbit
and full duplex.
>> eaddr -f p 0 s 100
The example below shows how to set the last three octets of the MAC addresses
of both interfaces, beginning with the address specified.
>> eaddr -ib 010000
Prints the nvram environment to the console.
env
Appendix D
Option indicating the specified Ethernet interface(s)
should be configured using the subsequent argument
as the last three octets of the MAC address. When the
-i option is used to indicate both interfaces are to be
configured, the specified argument is used as the
address for the "Network" port and the argument is
incremented for the "Server" interface address.
The last three octets of the address. This argument
should be entered as hex values.
Option indicating the specified Ethernet interface(s)
should be configured using the subsequent argument
as the octets of the MAC address. When the -i option
is used to indicate both interfaces are to be configured,
the specified argument is used as the address for the
"Network" port and the argument is incremented for
the "Server" interface address.
The octets of the address. This argument should be
entered as hex values.
MiniMax Command Summary
78-13124-05
Advertisement
Table of Contents
Troubleshooting
