Remoteport - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Appendix C
Command Summary
Syntax Description
Usage Guidelines
remoteport
Syntax Description
Caution
Usage Guidelines
Related Commands
78-13124-05
ipaddr
port
portid
facility
facilityid
Availability: Serial, Telnet; FIPS Mode (serial only)
Use the no form of the command to remove the specified log-url server from the
list. Only one log-url server can be configured.
Specifies the TCP service port through which non-secure connections is sent.
remoteport <port|default>
port
default
Traffic sent on this TCP service port is not secured by SSL during
transmission to the server. It must be secured by another means.
Availability: Serial, Telnet; FIPS Mode (serial only)
localport (Server Configuration Command Set)
sslport (Server Configuration Command Set)
Cisco 11000 Series Secure Content Accelerator Configuration Guide
The IP address of the device to receive log-url
messages.
Keyword indicating that a specific TCP port should be
used for communications.
The TCP port to be used.
Keyword indicating a specific facility should be used.
A numeral (from 0 to 7, inclusive) specifying the
facility to be used.
The non-secure port used to send clear text traffic to
the server.
Sets the non-secure port specification to 80.
Configuration Command Set
C-157
Advertisement
Table of Contents
Troubleshooting
