Suspend; Tcp-Tuning - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Appendix C
Command Summary
Related Commands
suspend
Syntax Description
Usage Guidelines
Related Commands
tcp-tuning
78-13124-05
sslv2 enable(Backend Server Configuration Command Set)
tlsv1 enable (Backend Server Configuration Command Set)
Suspends the function of the backend server.
suspend [now]
now
Availability: Serial, Telnet; FIPS Mode (serial only)
This command behaves in three ways:
•
If you are creating a new backend server and you use the suspend command,
the server is created in the suspended state. No connections are accepted until
the activate command is used.
If you are editing an existing backend server and you use the suspend
•
command alone, the all open connections on the server are finished, and no
new connections are accepted. No connections are accepted until the activate
command is used.
If you are editing an existing backend server and you use the suspend now
•
command, all connections are suspended. When the end command is entered,
the current backend server is removed, and a new suspended backend server
is created.
activate (Backend Server Configuration Mode)
Enters TCP Tuning Configuration mode at for this server.
tcp-tuning
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Suspends actions of the backend server immediately.
Configuration Command Set
C-115
Advertisement
Table of Contents
Troubleshooting
