Quit; Set Monitor-Interval - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Top Level Command Set
Syntax Description
Usage Guidelines
Related Commands
quit
Usage Guidelines
Related Commands
set monitor-interval
Cisco 11000 Series Secure Content Accelerator Configuration Guide
C-14
ipaddr
name
Availability: Serial, Telnet; FIPS Mode (serial only)
The host name can be used if a domain name has been assigned for the device.
When issued from a serial or telnet connection, the command returns information
based upon the hardware of the Secure Content Accelerator.
ip name-server (Configuration Command Set)
Quits the configuration manager.
quit
Availability: Serial, Telnet; FIPS Mode (serial only)
When executed from a serial connection, the connection is not closed. If an access
password has been configured, you are prompted for it. When executed from
telnet, the telnet connection is closed.
exit (Non-Privileged Command Set)
Sets the number of seconds between monitor-prefixed command refreshes.
set monitor-interval <value>
no set monitor-interval
The specified destination IP address.
The name of the host to ping (serial or telnet only).
Appendix C
Command Summary
78-13124-05
Advertisement
Table of Contents
Troubleshooting
