Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual page 200
11000 series secure content accelerator
Hide thumbs
Also See for CSS11501 - 100Mbps Ethernet Load Balancing Device:
- Hardware installation manual (184 pages) ,
- Datasheet (10 pages) ,
- Product support bulletin (3 pages)
Table of Contents
Advertisement
Methods to Manage the Device
•
•
Serial and telnet management commands can use symbolic hostnames in URL
identifiers if the ip domain-name has been set.
File name formats differ depending on the management method. When using the
GUI, you can specify the file name as it appears in the configuring computer's file
system. A path must be included, if necessary. When using serial or telnet
management, the file name must be entered in any of the following formats:
[<http:// | ftp:// | https:// | tftp:// >] URL
In situations where a file is written, anonymous write access must be configured
on the system with these caveats:
•
•
•
•
Additionally, we provide a guided QuickStart wizard configuration method,
available from both the configuration manager and GUI. To use this method for
configuration, see Chapter 3. Brief instructions are also included for initiating a
management session using the configuration manager.
For instructions on using the telnet and serial console CLI configuration
managers, see Chapter 4 for instructions on using the GUI, see Chapter 5.
Cisco 11000 Series Secure Content Accelerator Configuration Guide
C-8
Telnet connection, configuration manager
An IP address must have been assigned to the appliance.
–
A device cannot be set to single-port mode via telnet.
–
–
Cannot be used with Secure Content Accelerator in FIPS Mode.
Web browser-basedGUI
–
In IP address must have been assigned to the appliance for management.
A device cannot be set to single-port mode via the GUI.
–
Cannot be used with Secure Content Accelerator in FIPS Mode.
–
http:—The server must be configured to accept PUT commands
https:—The server must be configured to accept PUT commands
ftp:—If anonymous write access is not allowed, use this format:
ftp://username:password@hostname/directory/filename
tftp:—Use this format:
tftp://hostname/filename
where the hostname may be either a URL or IP address
Appendix C
Command Summary
78-13124-05
Advertisement
Table of Contents
Troubleshooting
