Table of Contents
Advertisement
4. Check:
• Brake hoses
Cracks/damage/wear → Replace.
EAS22730
ASSEMBLING THE REAR BRAKE MASTER
CYLINDER
EWA1S3L011
WARNING
• Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
• Never use solvents on internal brake com-
ponents.
• Whenever a master cylinder is disassem-
bled, replace the brake master cylinder kit.
Specified brake fluid
DOT 4
EAS22740
INSTALLING THE REAR BRAKE MASTER
CYLINDER
1. Install:
• Copper washers
New
• Brake hoses "1"
• Union bolt "2"
Brake hose union bolt
30 Nm (3.0 m·kg, 22 ft·lb)
EWA13530
WARNING
Proper brake hose routing is essential to in-
sure safe vehicle operation. Refer to "CABLE
ROUTING" on page 2-41.
ECA1S3L013
NOTICE
When installing the brake hose onto the
brake master cylinder, make sure the brake
pipe is installed between the projections "a"
and "b" as shown.
New
2
b
2. Fill:
• Brake fluid reservoir
(to the maximum level mark)
Specified brake fluid
DOT 4
EWA13090
WARNING
• Use only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
• Refill with the same type of brake fluid that
is already in the system. Mixing brake fluids
may result in a harmful chemical reaction,
leading to poor brake performance.
• When refilling, be careful that water does
not enter the brake fluid reservoir. Water
will significantly lower the boiling point of
the brake fluid and could cause vapor lock.
ECA13540
NOTICE
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean up
any spilt brake fluid immediately.
3. Bleed:
• Brake system
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" on page 3-22.
4. Check:
• Brake fluid level
Below the minimum level mark → Add the
specified brake fluid to the proper level.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-19.
5. Adjust:
• Brake pedal height
Refer to "ADJUSTING THE REAR DISC
BRAKE" on page 3-19.
4-40
REAR BRAKE
a
1
Advertisement
Chapters
Table of Contents
Troubleshooting
