Table of Contents
Advertisement
Camshaft runout limit
0.030 mm (0.0012 in)
EAS1S3L025
CHECKING THE DECOMPRESSION SYSTEM
1. Check:
• Decompression system
▼
▼▼▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
a. Check the decompression system with the
camshaft sprocket installed on and the de-
compressor lever pin installed in the cam-
shaft.
b. Check that the decompressor lever pin "1"
projects from the camshaft.
c. Check that the decompressor cam "2" moves
smoothly.
1
▲
▲▲▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
EAS23880
CHECKING THE ROCKER ARMS AND
ROCKER ARM SHAFTS
The following procedure applies to all of the
rocker arms and rocker arm shafts.
1. Check:
• Rocker arm
Damage/wear → Replace.
2. Check:
• Rocker arm shaft
Blue discoloration/excessive wear/pit-
ting/scratches → Replace or check the lubri-
cation system.
3. Measure:
• Rocker arm inside diameter
Out of specification → Replace.
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼▼▼
2
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲▲▲
5-16
Rocker arm inside diameter
12.000–12.018 mm (0.4724–
0.4731 in)
4. Measure:
• Rocker arm shaft outside diameter
Out of specification → Replace.
Rocker arm shaft outside diame-
ter
11.981–11.991 mm (0.4717–
0.4721 in)
5. Calculate:
• Rocker-arm-to-rocker-arm-shaft clearance
Out of specification → Replace the defective
part(s).
TIP
Calculate the clearance by subtracting the rock-
er arm shaft outside diameter from the rocker
arm inside diameter.
Rocker-arm-to-rocker-arm-shaft
clearance
0.009–0.037 mm (0.0004–0.0015
in)
EAS24040
INSTALLING THE CAMSHAFT AND ROCKER
ARMS
1. Install:
• Bearing "1"
(onto the camshaft)
CAMSHAFT
Advertisement
Chapters
Table of Contents
Troubleshooting
