Table of Contents
Advertisement
EAS29550
REMOVING THE BEARING RETAINER
1. Remove:
• Bearing retainer
Damper rod holder (30 mm)
90890-01327
Damper rod holder (30 mm)
YM-01327
EAS29560
CHECKING THE STEERING STEM
1. Check:
• Steering stem "1"
Bends → Replace.
EWA15030
WARNING
Do not attempt to straighten a bent stem; this
may dangerously weaken the stem.
2. Check:
• Oil seals "1"
New
• Steering stem bushings "2"
Wear/damage → Replace.
EAS29570
INSTALLING THE BEARING RETAINER
1. Install:
• Bearing retainer
Bearing retainer
65 Nm (6.5 m·kg, 47 ft·lb)
LOCTITE®
EAS29580
INSTALLING THE LOCK WASHER
1. Install:
2. Bend the lock washer tabs along a flat side of
1
EAS29590
INSTALLING THE PITMAN ARM
1. Install:
TIP
Make sure that the threads of the steering stem,
washers, nuts, and the installation surfaces of
the pitman arm are free of grease and oil.
4-47
STEERING STEM
Damper rod holder (30 mm)
90890-01327
Damper rod holder (30 mm)
YM-01327
• Lock washer
New
• Steering stem bushing bolts
Steering stem bushing bolt
23 Nm (2.3 m·kg, 17 ft·lb)
the bolts.
• Pitman arm
• Washer
• Pitman arm nut
• Cotter pin
New
Pitman arm nut
180 Nm (18.0 m·kg, 130 ft·lb)
New
Advertisement
Chapters
Table of Contents
Troubleshooting
