Table of Contents
Advertisement
2. Check:
• Brake hose "1"
Cracks/damage/wear → Replace.
1
1
3. Check:
• Brake hose clamp
Loose → Tighten the clamp bolt.
4. Apply the front brake several times.
5. Check:
• Brake hose
Brake fluid leakage → Replace the damaged
hose.
Refer to "FRONT BRAKES" on page 4-17.
6. Install:
• Front fender
• Fuel tank top panel
• Seat
Refer to "GENERAL CHASSIS" on page 4-1.
EAS21290
CHECKING THE REAR BRAKE HOSE
1. Check:
• Brake hose "1"
Cracks/damage/wear → Replace.
2. Check:
• Brake hose clamp
Loose connection → Tighten the clamp bolt.
3. Apply the rear brake several times.
4. Check:
• Brake hose
Brake fluid leakage → Replace the damaged
hose.
Refer to "REAR BRAKE" on page 4-28.
EAS29210
ADJUSTING THE PARKING BRAKE
1. Check:
• Parking brake cable end length "a"
Out of specification → Adjust.
1
2. Adjust:
• Parking brake cable end length
▼
▼▼▼
a. Slide back the rubber cover "1".
b. Loosen the locknut "2".
c. Turn the adjusting nut "3" in direction "a" or "b"
until the specified brake cable end length is
obtained.
1
d. Tighten the locknut.
e. Slide the rubber cover to its original position.
EWA1PE1005
WARNING
After this adjustment is performed, lift the
rear wheels off the ground by placing a block
under the engine, and spin the rear wheels to
ensure there is no brake drag. If any brake
drag is noticed perform the above steps
again.
▲
▲▲▲
3-21
Parking brake cable end length
47.0–51.0 mm (1.85–2.01 in)
a
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
b
1
3
2
a
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
CHASSIS
▼
▼ ▼▼▼
▼
▼▼▼
▲
▲ ▲▲▲
▲
▲▲▲
Advertisement
Chapters
Table of Contents
Troubleshooting
