Table of Contents
Advertisement
a
b
2. Apply:
• Sealant "1"
(onto the crankshaft position sensor/stator
assembly lead grommet)
Yamaha bond No. 1215
90890-85505
(Three bond No.1215®)
3. Install:
• Woodruff key
• AC magneto rotor
• Washer
• AC magneto rotor nut
TIP
• Clean the tapered portion of the crankshaft and
the AC magneto rotor hub.
• When installing the AC magneto rotor, make
sure the woodruff key is properly seated in the
keyway of the crankshaft.
4. Tighten:
• AC magneto rotor nut "1"
AC magneto rotor nut
60 Nm (6.0 m·kg, 43 ft·lb)
TIP
• While holding the AC magneto rotor "2" with
the sheave holder "3", tighten the AC magneto
rotor nut.
• Do not allow the sheave holder to touch the
projection on the AC magneto rotor.
AC MAGNETO AND STARTER CLUTCH
1
5. Install:
• Gasket
• AC magneto cover
• AC magneto cover bolts
1
TIP
Tighten the AC magneto cover bolts in stages,
using a crisscross pattern.
5-35
Sheave holder
90890-01701
Primary clutch holder
YS-01880-A
2
New
AC magneto cover bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
3
1
Advertisement
Chapters
Table of Contents
Troubleshooting
