Tacacs+ Commands; Tacacs-Server Host - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
TACACS+ Commands
OL-32830-01 Command Line Interface Reference Guide
51
51.1
tacacs-server host
To specify a TACACS+ host, use the tacacs-server host Global Configuration
mode command. To delete the specified TACACS+ host, use the no form of this
command.
Syntax
ip-address
tacacs-server host {
timeout
[timeout
] [key
encrypted tacacs-server host {
port-number
] [timeout
no tacacs-server host {
Parameters
•
ip-address
host
address can be an IPv4, IPv6 or IPv6z address.
•
hostname
host
characters. Maximum label length of each part of the host name: 63
characters)
•
single-connection—(Optional) Specifies that a single open connection is
maintained between the device and the daemon, instead of the device
opening and closing a TCP connection to the daemon each time it
communicates.
•
port-number
port
number. If the port number is 0, the host is not used for authentication.
(Range: 0-65535)
•
timeout
timeout
1-30)
hostname
|
key-string
priority
] [priority
ip-address
timeout
encrypted-key-string
] [key
ip-address
hostname
|
—Specifies the TACACS+ server host IP address. The IP
—Specifies the TACACS+ server host name. (Length: 1-158
—(Optional) Specifies the TACACS server TCP port
—(Optional) Specifies the timeout value in seconds. (Range:
} [single-connection] [port
]
hostname
|
} [single-connection] [port
] [priority
}
51
port-number
]
priority
]
997
Advertisement
Table of Contents
