Table of Contents
Advertisement
SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
Diagnostic code: sensor operation table
Diagnostic
code No.
01
Throttle position sensor
signal
• Fully closed position
03
Intake air pressure
05
Intake air temperature
06
Coolant temperature
07
Vehicle speed pulse
08
Lean angle sensor
• Upright
• Overturned
09
Fuel system voltage (bat-
tery voltage)
21
Neutral switch and clutch
switch
• Clutch lever is squeezed
with the transmission in
gear
• Transmission is in gear
or the clutch lever re-
leased
Item
14–20
Displays the intake air
pressure.
When engine is cold: Dis-
plays temperature closer
to ambient temperature.
When engine is hot: Dis-
plays ambient temperature
20 °C (68 °F).
When engine is cold: Dis-
plays temperature closer
to ambient temperature.
When engine is hot: Dis-
plays current coolant tem-
perature.
0–999
Lean angle sensor output
voltage
0.4–1.4
3.7–4.4
Approximately 12.0
ON
OFF
9-6
Display
Check with throttle valve
fully closed.
Push the start switch and
check that the intake air
pressure changes.
Check the temperature in
the intake manifold and air
filter case.
Check the coolant temper-
ature.
Check that the number in-
creases when the rear
wheels are rotated. The
number is cumulative and
does not reset each time
the wheel is stopped.
Remove the lean angle
sensor and incline it more
than 65 degrees.
Turn the main switch to
"
" (on), and then com-
pare the actually mea-
sured battery voltage with
the display value. (If the
actually measured battery
voltage is low, recharge
the battery.)
Operate the transmission
and clutch lever.
Procedure
Advertisement
Chapters
Table of Contents
Troubleshooting
