Show Mac Address-Table Dynamic - Cisco ME 3400 Command Reference Manual

Ethernet access switch

Hide thumbs Also See for ME 3400:

Table of Contents

show mac address-table dynamic

Use the show mac address-table dynamic user EXEC command to display only dynamic MAC address

table entries.

Syntax Description

address mac-address

interface interface-id

vlan vlan-id

Command Modes

Command History

Usage Guidelines

Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output

do not appear, but the lines that contain Output appear.

This is an example of output from the show mac address-table dynamic command:

Switch> show mac address-table dynamic

------------------------------------------

Total Mac Addresses for this criterion: 2

Cisco ME 3400 Ethernet Access Switch Command Reference

show mac address-table dynamic [address mac-address] [interface interface-id] [vlan vlan-id]

[ | {begin | exclude | include} expression]

(Optional) Specify a 48-bit MAC address; the valid format is H.H.H

(available in privileged EXEC mode only).

(Optional) Specify an interface to match; valid interfaces include physical

ports and port channels.

(Optional) Display entries for a specific VLAN; the range is 1 to 4094.

(Optional) Display begins with the line that matches the expression.

(Optional) Display excludes lines that match the expression.

(Optional) Display includes lines that match the specified expression.

Expression in the output to use as a reference point.

Modification

This command was introduced.

Mac Address Table

0030.b635.7862

DYNAMIC Gi0/2

00b0.6496.2741

DYNAMIC Gi0/2

Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands