Show Interfaces Transceivers - Cisco ME 3400 Command Reference Manual
Ethernet access switch
Hide thumbs
Also See for ME 3400:
- Software configuration manual (1138 pages) ,
- Command reference manual (872 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
show interfaces transceivers
show interfaces transceivers
Use the show interfaces transceivers privileged EXEC command to display the physical properties of
a small form-factor pluggable (SFP) module interface.
Syntax Description
interface-id
detail
supported-list
threshold-table
module number
properties
threshold-table
| begin
| exclude
| include
expression
Command Modes
User EXEC
Command History
Release
12.2(25)EY
12.2(44)SE
Usage Guidelines
The threshold values shown in the outputs from the show interfaces transceiver threshold-table and
the show interfaces transceiver detail are not the same. The thresholds shown in the output from the
show interfaces transceiver threshold-table command are hard-coded in Cisco IOS, but are not
supported.
The thresholds shown in the output from the show interfaces transceiver detail command are read from
the SFP EEPROM and are supported. You should always use the show interfaces transceiver detail
command to view transceiver thresholds.
Cisco ME 3400 Ethernet Access Switch Command Reference
2-454
show interfaces [interface-id] transceiver [detail | module number | properties | supported-list |
threshold-table] [ | {begin | exclude | include} expression]
(Optional) Display configuration and status for a specified physical
interface.
(Optional) Display calibration properties, including high and low numbers
and any alarm information for any Digital Optical Monitoring
(DoM)-capable transceiver if one is installed in the switch.
(Optional) List all supported DoM transceivers.
(Optional) Display alarm and warning threshold table.
Note
(Optional) Limit display to interfaces on module on the switch. The range
is 1 to 9. This option is not available if you entered a specific interface ID.
(Optional) Display speed, duplex, and inline power settings on an interface.
(Optional) Display alarm and warning threshold table
(Optional) Display begins with the line that matches the expression
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
The dom-supported-list and threshold-table keywords were added.
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
This keyword displays the thresholds that are programmed into SFP
hardware and are not those used to determine when to send alarms or
traps. To view those thresholds, enter the show interfaces
transceiver detail command.
OL-9640-10
Advertisement
Table of Contents
