Cisco ME 3400 Command Reference Manual page 330

Ethernet access switch

Hide thumbs Also See for ME 3400:

Table of Contents

pagp learn-method

When the link partner to the Cisco ME switch is a physical learner, we recommend that you configure

the switch as a physical-port learner. Use the pagp learn-method physical-port interface configuration

command, and set the load-distribution method based on the source MAC address by using the

port-channel load-balance src-mac global configuration command. Only use the pagp learn-method

interface configuration command in this situation.

This example shows how to set the learning method to learn the address on the physical port within the

EtherChannel:

Switch(config-if)# pagp learn-method physical-port

This example shows how to set the learning method to learn the address on the port-channel within the

EtherChannel:

Switch(config-if)# pagp learn-method aggregation-port

You can verify your settings by entering the show running-config privileged EXEC command or the

show pagp channel-group-number internal privileged EXEC command.

Related Commands

pagp port-priority

show running-config

Cisco ME 3400 Ethernet Access Switch Command Reference

Selects a port over which all traffic through the EtherChannel is sent.

Displays PAgP channel-group information.

Displays the operating configuration. For syntax information, use this link to

the Cisco IOS Release 12.2 Command Reference listing page:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command_

reference_list.html

Select the Cisco IOS Commands Master List, Release 12.2 to navigate to

the command.

Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands