Cisco ME 3400 Command Reference Manual page 320

Ethernet access switch

Hide thumbs Also See for ME 3400:

Table of Contents

mvr (global configuration)

This example shows how to enable MVR:

Switch(config)# mvr

Use the show mvr privileged EXEC command to display the current setting for maximum multicast

This example shows how to configure 228.1.23.4 as an IP multicast address:

Switch(config)# mvr group 228.1.23.4

This example shows how to configure ten contiguous IP multicast groups with multicast addresses from

228.1.23.1 to 228.1.23.10:

Switch(config)# mvr group 228.1.23.1 10

Use the show mvr members privileged EXEC command to display the configured IP multicast group

This example shows how to set the maximum query response time as one second (10 tenths):

Switch(config)# mvr querytime 10

This example shows how to set VLAN 2 as the multicast VLAN:

Switch(config)# mvr vlan 2

You can verify your settings by entering the show mvr privileged EXEC command.

Related Commands

mvr (interface configuration)

show mvr interface

show mvr members

Cisco ME 3400 Ethernet Access Switch Command Reference

Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands

Configures MVR ports.

Displays MVR global parameters or port parameters.

Displays the configured MVR interfaces with their type, mode,

VLAN, status and Immediate Leave configuration, and can also

displays all MVR groups of which the interface is a member.

Displays all ports that are members of an MVR multicast group;

if the group has no members, its status is shown as Inactive.