Dot1X Default - Cisco ME 3400 Command Reference Manual
Ethernet access switch
Hide thumbs
Also See for ME 3400:
- Software configuration manual (1138 pages) ,
- Command reference manual (872 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
dot1x default
dot1x default
Use the dot1x default interface configuration command to reset the configurable IEEE 802.1x
parameters to their default values.
Syntax Description
This command has no arguments or keywords.
Defaults
These are the default values:
•
•
•
•
•
•
•
•
•
Command Modes
Interface configuration
Command History
Release
12.2(25)EX
Examples
This example shows how to reset the configurable IEEE 802.1x parameters on a port:
Switch(config-if)# dot1x default
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands
Command
show dot1x
Cisco ME 3400 Ethernet Access Switch Command Reference
2-86
dot1x default
The per-port IEEE 802.1x protocol enable state is disabled (force-authorized).
The number of seconds between re-authentication attempts is 3600 seconds.
The periodic re-authentication is disabled.
The quiet period is 60 seconds.
The retransmission time is 30 seconds.
The maximum retransmission number is 2 times.
The host mode is single host.
The client timeout period is 30 seconds.
The authentication server timeout period is 30 seconds.
Modification
This command was introduced.
[interface interface-id]
Chapter 2
Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
Description
Displays IEEE 802.1x status for the specified port.
OL-9640-10
Advertisement
Table of Contents
