Cisco ME 3400 Command Reference Manual page 228

Ethernet access switch

Hide thumbs Also See for ME 3400:

Table of Contents

ip sticky-arp (interface configuration)

To enable sticky ARP on a normal SVI:

Switch(config-if)# ip sticky-arp

To disable sticky ARP on a Layer 3 interface or an SVI:

Switch(config-if)# no ip sticky-arp

You can verify your settings by using the show arp privileged EXEC command.

Related Commands

Cisco ME 3400 Ethernet Access Switch Command Reference

If you disconnect the switch from a device and then connect it to another device with a different

MAC address but with the same IP address, the ARP entry is not created, and this message appears:

*Mar 2 00:26:06.967: %IP-3-STCKYARPOVR: Attempt to overwrite Sticky ARP entry:

20.6.2.1, hw: 0000.0602.0001 by hw: 0000.0503.0001

If a MAC address of a device changes, you must use the no arp ip-address global configuration

command to manually remove the private-VLAN interface ARP entries.

Use the arp ip-address hardware-address type global configuration command to add a

private-VLAN ARP entry.

Use the no sticky-arp global configuration command to disable sticky ARP on the switch.

Use the no sticky-arp interface configuration command to disable sticky ARP on an interface.

Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands

Adds a permanent entry in the ARP table. For syntax information,

see the Cisco IOS IP Addressing Services Command Reference,

Release 12.4 > ARP Commands.

Displays the entries in the ARP table. For syntax information, see the

Cisco IOS IP Addressing Services Command Reference,

Release 12.4 > ARP Commands.