Cisco ME 3400 Command Reference Manual page 913
Ethernet access switch
Hide thumbs
Also See for ME 3400:
- Software configuration manual (1138 pages) ,
- Command reference manual (872 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
Appendix C
Cisco ME 3400 Ethernet Access Switch Show Platform Commands
transmit {port-fifo | queue |
supervisor-sram} [asic number |
port number [asic number]]
vct [asic number | port number
[asic number]]
| begin
| exclude
| include
expression
Though visible in the command-line help strings, the stack {control | dest-map | learning | messages |
Note
mvid | prog-parser | span | stats [asic number | port number [asic number]] keywords are not
supported.
Command Modes
Privileged EXEC
Command History
Release
12.2(25)EX
Usage Guidelines
You should use this command only when you are working directly with your technical support
representative while troubleshooting a problem. Do not use this command unless your technical support
representative asks you to do so.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
OL-9640-10
Display transmit information. The keywords have these meanings:
port-fifo—Display the contents of the port-FIFO information
•
register.
queue—Display the contents of the queue information
•
register.
supervisor-sram—Display supervisor SRAM information.
•
asic number—(Optional) Display information for the
•
specified ASIC. The range is 0 to 1.
port number—(Optional) Display information for the
•
specified port and ASIC number. The range is 0 to 27, where
0 is the supervisor and 1 to 25 are the ports.
Display the VLAN compression table entries for the specified
ASIC or for the specified port and ASIC. The keywords have these
meanings:
•
asic number—(Optional) Display information for the
specified ASIC. The range is 0 to 1.
port number—(Optional) Display information for the
•
specified port and ASIC number. The range is 0 to 27, where
0 is the supervisor and 1 to 25 are the ports.
(Optional) Display begins with the line that matches the
expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified
expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Cisco ME 3400 Ethernet Access Switch Command Reference
show platform port-asic
C-33
Advertisement
Table of Contents
