Show Platform Ip Unicast - Cisco ME 3400 Command Reference Manual
Ethernet access switch
Hide thumbs
Also See for ME 3400:
- Software configuration manual (1138 pages) ,
- Command reference manual (872 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
show platform ip unicast
show platform ip unicast
Use the show platform ip unicast privileged EXEC command to display platform-dependent IP unicast
routing information.
Syntax Description
adjacency
cef-idb
counts
dhcp
failed {adjacency |
arp [A.B.C.D] | route}
loadbalance
mpaths
route
standby
statistics
trace
| begin
| exclude
| include
expression
Note
Though visible in the command-line help strings, the proxy and table keywords are not supported.
Command Modes
Privileged EXEC
Command History
Release
12.2(25)EX
Cisco ME 3400 Ethernet Access Switch Command Reference
C-14
show platform ip unicast {adjacency | cef-idb | counts | dhcp | failed {adjacency | arp [A.B.C.D]
| route} | loadbalance | mpaths | route | standby | statistics | trace} [ | {begin | exclude |
include} expression]
Display the platform adjacency database.
Display platform information corresponding to Cisco Express Forwarding
(CEF) interface descriptor block.
Display the current counts for the Layer 3 unicast databases.
Display the DHCP system dynamic addresses.
Display the hardware resource failures. The keywords have these meanings:
•
adjacency—Display the adjacency entries that failed to be programmed
in hardware.
•
arp—Display the Address Resolution Protocol (ARP) deletions because
of failure and because of retries.
A.B.C.D—(Optional) Prefix of the ARP entries to display.
•
route—Display the route entries that failed to be programmed in
•
hardware.
Display the platform load balancing database.
Display the Layer 3 unicast routing multipath adjacency database.
Display the platform route database.
Display the platform standby information.
Display the Layer 3 unicast routing accumulated statistics.
Display the platform event trace logs.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Appendix C
Cisco ME 3400 Ethernet Access Switch Show Platform Commands
OL-9640-10
Advertisement
Table of Contents
