Table of Contents
Advertisement
1
Setup
Custom Settings
Volume Settings
Beeper Volume
You can set the beeper to LOW, HIGH or OFF. The MFC comes set to LOW. When the beeper is
set to LOW or HIGH, the MFC beeps every time you press a key or make an error, and at the end
of sending or receiving a fax.
1
Press Menu, 1, 1, 4.
2
Press
or
to select your setting.
3
When the screen displays the setting you want, press Set.
4
Press Stop to exit.
Speaker Volume
You can adjust the speaker volume when your MFC has dialled (on hook dialing), the line is
connected and TELEPHONE is on the display. You can turn the volume OFF or you can select a
volume level.
Press
or
to adjust the volume level. The display shows the setting you are choosing. Each key
press changes the volume to the next setting. The new setting will remain until you change it again.
Ring Volume
You can adjust the ring volume when your MFC is idle. The ring volume can be turned off for silent
reception if required.
Press
or
to adjust the volume level. With each key press, the MFC rings so you can hear the
current setting and the display shows the setting you are choosing. Each key press changes the
volume to the next setting.
The new setting will remain until you change it again.
PABX and TRANSFER
Your MFC is initially set to be connected with PSTN (Public Switched Telephone Network) lines.
However many offices use a central telephone system or Private Automatic Branch Exchange
(PABX). Your MFC can be connected to most types of PABX. You can easily gain access to the
outside line from your MFC connected to PABX by just pressing Shift and R.
Also, you can transfer a call to another extension by pressing Shift and R.
Setting PABX
If your MFC is connected to a PABX system, set PBX:ON. If not, set OFF.
1
Press Menu, 1, 1, 5. The screen displays
2
to select ON (or OFF), and press Set
Press
or
when the screen displays your selection.
3
Press Stop to exit.
18
Chapter 1
PBX:OFF
SELECT { } & SET
Advertisement
Table of Contents
