Table of Contents
Advertisement
KEY OPERATOR'S GUIDE
Printer Exposure Level
This program is used to adjust the lightness or darkness of documents in the printer mode. The
factory default is level '3'.
When the "PRINTER EXPOSURE LEVEL" key is pressed, the following display will appear.
KEY OPERATOR PROGRAMS
PRINTER EXPOSURE LEVEL
Memory Reserved for Printer
This program is used to specify the percentage of document memory allocated to storage of printer
jobs. In the default setting, the memory capacity for printer jobs is 30% (60 pages for A4 or 8-1/2" x
11"). To print documents that exceed this limit, increase the percentage using this program.
When the "MEMORY RESERVED FOR PRINTER" key is pressed, the following display will appear.
NOTE
This program can be used only for models with a 1 GB hard disk drive. For models with a 2 GB or more hard disk
drive or no hard disk drive, this program cannot be used.
KEY OPERATOR PROGRAMS
MEMORY RESERVED FOR PRINTER
30%
45%
60%
NOTES
If '30%' is specified, the maximum number of pages in a block is 60 for A4, letter or smaller sizes. If '60%' is
specified, the maximum number is 120 for A4, letter or smaller sizes.
Since the memory in this printer is used for both copier and printer features, the setting of this program will affect
copying performance. Assign an appropriate value.
OK
OK
35%
40%
50%
55%
1. Set the desired density level using the "
and "
" keys.
2. Press the "OK" key.
1. Select the desired percentage.
2. Press the "OK" key.
42
"
Advertisement
Table of Contents
Troubleshooting
