Table of Contents
Advertisement
APPENDIX
Supplement
•
This printer is not equipped with a hard disk drive for additional fonts. Any downloaded fonts cannot
be stored permanently.
•
If you try to start printing through the parallel interface before the printer is turned on or while the
message "INITIALIZING. PLEASE WAIT." is displayed on the touch panel immediately after the
printer is turned on, printing may not be performed properly. Be sure to start printing through the
parallel interface after ensuring that the printer becomes online.
•
Depending on printing data, "VM error" or "Memory Full" error message may be printed on a page
or improper printing (some images or characters are missing) may occur. This error occurs
because of insufficient memory when printing a lot of data or complicated data. This error may be
avoided by adding an additional memory to the printer kit. If this error occurs frequently, contact
your dealer.
•
With the PPD driver for Windows NT 4.0, the printer resident fonts cannot be specified. Font
downloading, therefore, is always performed when printing is executed. To use the printer resident
fonts under Windows NT 4.0, install the PS, PCL5e or PCL6 driver.
•
When printing multiple copies, this printer prints each set sequentially. (This printer does not print all
copies of each page at a time.)
•
If the setting "collate" exists in the print dialog box or application's print settings, do not select this
setting. This setting is not necessary because this printer always performs collated printing. If this
setting is selected, two-sided printing or stapling with multiple copies may not be performed
properly.
•
Take care to see the message on the touch panel when adding A4, B5 or 8-1/2" x 11" (letter) paper
in the bypass tray in a print job. If 'R' is added to the paper size, for example, "LOAD A4R PAPER.",
set the paper narrow side into the feed slot. If 'R' is not added to the paper size, set the paper wide
side into the feed slot.
•
To print onto A4R, B5R or 8-1/2" x 11"R paper, specify the tray in which the desired paper has
been loaded. If the auto paper select function selects these sizes against your intention, consult
with your key operator about setting the key operator program "PROHIBIT ROTATED OUTPUT".
•
If paper must be added when paper has run out in the middle of a print job, be sure to set the paper
in the same orientation. If the orientation is changed in the middle of a print job, part of images may
not be printed. Image rotation will not occur in the middle of a print job.
•
When setting A5 or 5-1/2" x 8-1/2" (invoice) size paper in a paper tray or in the bypass tray, be sure
to set the paper wide side into the feed slot. If not, part of images may not be printed.
•
When setting A6, Japanese postcard, 10-1/2" x 7-1/4" (executive) or custom size paper in a paper
tray or in the bypass tray, be sure to set the paper narrow side into the feed slot. If not, part of
images may not be printed.
•
If any tray is open when a print job is sent to the printer, part of images may not be printed. Be sure
to start printing after ensuring that all the trays are closed.
68
2001A
DSC2
CINSE1992FC51
Advertisement
Table of Contents
Troubleshooting
