Table of Contents
Advertisement
KEY OPERATOR'S GUIDE
Enable Bypass-Tray Size Detection
This program is used to enable or disable paper size detection of the bypass tray in the printer mode.
This setting does not affect the paper size detection in the copier mode.
To enable paper size detection of the bypass tray in the printer mode, press the "ENABLE BYPASS-
TRAY SIZE DETECTION" box to display a check mark.
To disable paper size detection, press the checked box again to clear the check mark.
NOTE
If size detection of the bypass tray is disabled, paper in the bypass tray will always be treated as the largest
allowable size paper (either 11" x 17" or A3). If an image larger than the paper in the bypass tray is printed, a
malfunction may occur. Be careful when disabling the size detection.
Give Priority to Print Speed in Staple Mode
This program is used to select one of the two image processing methods for printing with stapling. If
this program is set, the printer will start printing while storing image data. The printing speed will be
higher. If improper paper size for stapling is found or the number of sheets exceeds the limit for
stapling, however, printing will stop. If this program is not set, the printer will start printing after
storing all image data. The printing speed will be lower. If an error data such as improper paper size
is received, however, the printer will continue printing without stapling. This program is set in the
factory default setting.
To give priority to printing speed, press the "GIVE PRIORITY TO PRINT SPEED IN STAPLE
MODE" box to display a check mark.
To cancel priority to printing speed, press the checked box again to clear the check mark.
NOTE
This program can be applied to the AR-505 and AR-507.
Prohibit Notice Page Printing
This program is used to specify whether a notice page and separator sheets will be printed when the
printer memory becomes full and divided printing must be performed. If notice page printing has
been enabled, a notice page will be printed at the end of a print job and separator sheets will be
printed between each block letting the user know that the job has been divided into blocks and the
user must re-stack the document.
To prohibit notice page printing, press the "PROHIBIT NOTICE PAGE PRINTING" box to display a
check mark.
To restore notice page printing, press the checked box again to clear the check mark.
44
Advertisement
Table of Contents
Troubleshooting
