Table of Contents
Advertisement
USING THE OPERATION PANEL
NOTES
If configuration settings are protected using key operator programs (Prohibit Changes to Printer Settings and
Prohibit Changes to Interface Settings), the settings cannot return to the factory default setting and stored settings
cannot be recalled.
Use the key operator programs to cancel protection mode.
If the setting of functions of enabling protocols (ENABLE TCP/IP, ENABLE NetWare, and ENABLE EtherTalk) is
changed by using the function "RESTORE FACTORY DEFAULTS" or "RESTORE CONFIGURATION", the new
setting will be effective after resetting the printer. To reset the printer, turn off the printer and then turn it on after a
few seconds.
The "Restore Factory Defaults" setting does not restore network settings. To return the network settings to the
factory default settings, use the "RESET THE NIC" function.
Copier Mode and Printer Mode
The COPY and PRINT keys can be used to set whether the copier/printer is in the copier mode or
printer mode. The PRINT indicator (see Figure 4-1) lights up when the copier/printer is in the printer
mode; the COPY indicator (see Figure 4-1) lights up when the copier mode is in effect. The default
status is the mode that was selected at the time power was last turned off.
When the copier mode is in effect, pressing the PRINT key will change the setting to the printer
mode. If a document is sent to the printer from a computer when the copier mode is in effect and a
copying operation is not being performed, printing will be performed but the copier mode remains in
effect.
When the printer mode is in effect and no document is being printed, pressing the COPY key will
change the setting to the copier mode.
When the printer mode is in effect and a document is being printed, pressing the COPY key will
change the setting to the copier mode but will not interrupt the current print job until the START key
is pressed. When the copying job is complete, the print job will resume automatically but the copier
mode will remain in effect.
NOTE
If copying is performed, the print job will resume when no copier operation is performed for a programmed period of
time. To resume printing immediately after copying is complete, press the PRINT key.
Selecting the Online Mode
If the printer is in the offline mode, printing cannot be performed. To select the online mode, use the
procedure below.
1. If the printer is in the copier mode, press the PRINT key to select the printer mode.
The basic screen of the printer mode will appear.
2. Press the "ONLINE/OFFLINE" key on the touch panel to switch the printer to the online mode.
3. Press the COPY key to select the copier mode.
36
Advertisement
Table of Contents
Troubleshooting
