Table of Contents
Advertisement
[7] ADJUSTMENTS
1. Paper guide position adjustment in the
manual paper feed section
(Printer model)
A. Correction value entry procedure
*
This setup is used to enter the detection level to the printer when
installing, etc.
1) Turn the main switch on while pressing the [MENU] key and
the [OK] key of the operation panel of the main unit of the printer.
"ON"
2) After pressing the [MENU] key several times to display
"SIZE ADJUSTMENT A" in the message display, press the [
to display "SIZE ADJUSTMENT B" and press the [OK] key.
3) "MAXIMUM SIZE" is displayed.
Since "MAXIMUM SIZE" is displayed with a number, press
the [
] key or the [
] key to change the number so that the
number is equal to the value of [MAX] written on the label(*NOTE)
and then press the [OK] key.
4) Since "P1 SIZE" is displayed with a number, press the [
the [
] key to change the number so that the number is equal to the
value of [P1] written on the label(*NOTE) and then press
the [OK] key.
5) Since "P2 SIZE" is displayed with a number, press the [
the [
] key to change the number so that the number is equal to the
value of [P2] written on the label(*NOTE) and then press
the [OK] key.
6) Since "MINIMUM SIZE" is displayed with a number, press
the [
] key or the [
] key to change the number so that the
number is equal to the value of [MIN] written on the label (*NOTE)
and then press the [OK] key.
7) Turn off the main switch to cancel the setting mode.
B. Alignment of the guide plate and the size mark
*
This setup is used when the paper width sensor does not work
correctly or when it is replaced with a new one.
1) Press and hold [MENU] key and [OK] key together, and turn on the
main switch.
2) Press [MENU] key several times until "SIZE ADJUSTMENT A" is
displayed. Press the [
and press [OK] key.
3) "MAXIMUM ISZE" is displayed.
Move the manual feed guide F to the maximum position, and press
[OK] key.
] key
4) "P1 SIZE" is displayed. Move the manual paper feed guide F to the
size mark of A4R on the manual paper feed tray upper, and press
[OK] key.
5) "P2 SIZE" is displayed. Move the manual paper feed guide F to the
size mark of A5R on the manual paper feed tray upper, and press
[OK] key.
] key or
] key or
6) "MINIMUM SIZE" is displayed. Move the manual paper feed guide F
to the minimum position, and press [OK] key.
7) Turn off the main switch to cancel the setting mode.
AR-DU3/DU4/TE3 ADJUSTMENTS 7-1
"ON"
] key to display "SIZE ADJUSTMENT C,"
Advertisement
Table of Contents
