Table of Contents
Advertisement
[6] MACHINE OPERATION
1. Setting the printer driver for duplex
module, bypass tray and exit tray
When using the duplex module (including the bypass tray and the exit
tray) for printing, select "Properties" and make selections as follows for
the print job.
*
The screens used in the following descriptions are for a PCL driver in
the Windows 98 environment.
A. Two-sided printing
Open the "Main" tab and check the radio button of the desired two-sided
printing mode.
B. Using the bypass tray
Open the "Paper" tab shown in the illustration below and select "Bypass
Tray" in the "Paper Selection" drop down.
C. Using the exit tray mounted to the duplex module
Open the "Paper" tab shown in the illustration below and select "Left Side
Tray" in the "Output" drop down.
Note: The settings screens above will appear only if the devices have
been set properly in the printer driver configuration
2. Copying in the duplex mode
For copying in the duplex mode, press the COPY key on the operation
panel and make all selections on the copy mode basic screen.
A. Automatic duplex copying
Touch the [2-SIDED COPY] key on the copy mode basic screen.
A selection screen for two-sided copying will appear.
B.Using the bypass tray
Touch the [PAPER SELECT] key on the copy mode basic screen.
A selection screen for paper source will appear. Select the bypass tray
on this screen.
C. Using the exit tray
Touch the [OUTPUT] key on the copy mode basic screen.
A selection screen for output will appear. Select the exit tray mounted to
the duplex module on this screen.
AR-DU3/DU4/TE3 MACHINE OPERATION 6-1
Advertisement
Table of Contents
