Table of Contents
Advertisement
5. From this page you can make changes to the items as listed in the following table:
E-mail Setup
Item
Name
Machine Code
Machine
Location
Primary E-mail
Server
Secondary
E-mail Server
E-mail Time Out
Reply Address
Time Zone
•
To perform network scanner setting, enter the data for the network scanning setup items. (See
the network scanner operation manual.) If a host name for the e-mail server has been entered,
enter its IP address on this screen.
Description
Enter a unique name for the machine within 50 characters.
This is not used. This field can be used to input some machine related
information. Some dealers may use this field to identify the machine.
Enter a unique entry for the machine location within 100 characters.
Enter an IP address for the primary e-mail server or a host name.
Enter an IP address for the secondary e-mail server or a host name. No need
to enter if secondary e-mail server is not set up.
Enter a time out period, from 0 to 60 seconds, that the system will wait for as
it attempts to connect to the primary server. The default is 20 seconds. If no
connection is made, the system will then look for the secondary server if it has
been set up. If not, the system will stop attempting to connect.
Enter an e-mail address to which the machine returns an unsuccessful
delivery message when the distribution has failed. Only 1 e-mail address can
be entered. The entered e-mail address is also used as sender e-mail
address.
Select the time zone of the place to use this Network Scanning System. A
specific time zone is set after the selection.
51
KEY OPERATOR'S GUIDE
Advertisement
Table of Contents
Troubleshooting
