Removing A Line Card Cable-Management Bracket; Cables And Connectors; Gigabit Ethernet Interfaces; Gigabit Ethernet Sfp Modules - Cisco ASR 9000 Series Installation Manual
Aggregation services router ethernet line card
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Cables and Connectors
Removing a Line Card Cable-Management Bracket
To remove a line card cable-management bracket, follow these steps
Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 1
Note the current interface cable connections to the ports on each line card.
Step 2
Starting with the interface cable for the bottom port on the line card, disconnect the cable from the line
Step 3
card interface.
Repeat
Step 4
to
Step
Loosen the captive installation screw on the cable-management bracket and remove the bracket from the
Step 5
line card
For information on connecting and disconnecting interface cables, see
Fiber-Optic Interface Cables, page
Cables and Connectors
•
•
•
•
•
•
Gigabit Ethernet Interfaces
•
•
Gigabit Ethernet SFP Modules
The 40-Port Gigabit Ethernet (GE) line card and the Gigabit Ethernet ports of the 2-Port 10 GE + 20-Port
GE combination line card use SFP modules. The Gigabit Ethernet laser optical transceiver module is a
field-replaceable small form-factor pluggable (SFP) module that plugs into the receptacle (or cage)
located on the line card and provides the Gigabit Ethernet optical interface
has two optical interfaces—laser transmit (TX) and laser receive (RX)—and an electrical interface (to
the line card).
The SFP+ modules used on the 16-Port 10GE oversubscribed line card are enhanced SFP modules.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
2-68
Step 3
for all remaining interface cables, proceeding from the bottom ports upward, then proceed
5.
(Figure
2-43).
Gigabit Ethernet Interfaces, page 2-68
Fiber-Optic Interface Cables, page 2-70
Installing and Removing Fiber-Optic Interface Cables, page 2-71
Cleaning Fiber-Optic Connectors, page 2-73
Type RJ-45 10/100/1000BASE-T Copper Cables, page 2-74
Removing and Installing RJ-45 10/100/1000BASE-T Copper Cables, page 2-74
Gigabit Ethernet SFP Modules, page 2-68
10-Gigabit Ethernet XFP Modules, page 2-70
Chapter 2
Installing Line Cards in the Cisco ASR 9000 Series Router
2-71.
(Figure
2-43):
Installing and Removing
(Figure
2-44). The module
Advertisement
Table of Contents
Troubleshooting
