Using Show Commands To Display Modular Port Adapter Information - Cisco ASR 9000 Series Installation Manual
Aggregation services router ethernet line card
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Installing and Removing Modular Port Adapters
Using show Commands to Display Modular Port Adapter Information
Table 2-1
information.
Table 2-1
Command
show running-config
show platform
show diag
show hw-module fpd location
<rack/slot/subslot>
show version
Table 2-2
show Commands to Display Modular Port Adapter Information
Command
show controllers type
rack/slot/subslot/port
show interfaces type
rack/slot/subslot/port
show diag rack/slot/subslot/
show version
Note
When a MLC is moved to a new slot, the system recognizes the new interfaces but leaves them in the
shutdown state until you configure them and change their state to up. When a new MLC is inserted into
a slot where a MLC previously resided, provided you reinstall the modular port adapters (MPAs) and
interfaces and their cables in the same configuration as in the previous MLCs, the interfaces will come
up in the same state as though you reinserted the old MLC.
The following sample display shows the events logged by the system as you insert a new MLC in module
slot 4.
RP/0/RSP0/CPU0:Dec 21 21:55:50.318 : invmgr[246]: %PLATFORM-INV-6-OIRIN : OIR: Node
0/4/CPU0 inserted
...
RP/0/RSP0/CPU0:Dec 21 21:59:12.979 : shelfmgr[371]: %PLATFORM-SHELFMGR-6-NODE_STATE_CHANGE
: 0/4/0 A9K-MPA-4X10GE state:INITIALIZED
..
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
2-24
describes the show commands you can use to display modular port adapter (MPA)
show Commands to Display Modular Port Adapter Information
Type of Information Provided
Router's running configuration and interfaces available in the
system.
Router's installed line card and MPA type, slot, and state
information.
MPA type in that slot, number of ports, hardware revision, part
number, and EEPROM contents.
FPD version information of modular port adapters (MPAs) in the
system.
Cisco IOS XR software version, names and sources of configuration
files, and boot images.
Type of Information Provided
Network link status, register contents, and
controller chip errors.
Line status and data link protocol status for a
particular MPA port. Statistics about data traffic
sent and received by the port.
MPA type in that slot, number of ports, hardware
revision, part number, and EEPROM contents.
Cisco IOS XR software version and boot images. show version
Chapter 2
Installing Line Cards in the Cisco ASR 9000 Series Router
Example
show controllers Gigabit Ethernet
0/0/1/1
show interfaces Gigabit Ethernet
0/0/1/1
show diag 0/0/1
Advertisement
Table of Contents
Troubleshooting
