Attaching The Optical Network Cable - Cisco ASR 9000 Series Installation Manual
Aggregation services router ethernet line card
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Cisco 40-Gigabit QSFP+ Transceiver Modules Installation
Figure 2-35
For optical QSFP+ modules, reinstall the dust plug into the QSFP+ transceivers optical bore until you
Step 8
are ready to attach the network interface cable. Do not remove the dust plug until you are ready to attach
the network interface cable.
Attaching the Optical Network Cable
Note
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
2-56
Seating the 40-Gigabit QSFP+ Transceiver Module (Optical Transceiver Equipped with
a Bail-Clasp Latch Shown)
Before removing the dust plugs and making any optical connections, follow these guidelines:
Keep the protective dust plugs installed in the unplugged fiber-optic cable connectors and in the
–
transceiver optical bores until you are ready to make a connection.
Inspect and clean the MPO connector end faces just before you make any connections. See the
–
Tip following step 2 in the next procedure for a pointer to a fiber-optic inspection and cleaning
white paper.
–
Grasp the MPO connector only by the housing to plug or unplug a fiber-optic cable.
40-Gigabit QSFP+ transceiver modules are keyed to prevent incorrect insertion.
Chapter 2
Installing Line Cards in the Cisco ASR 9000 Series Router
Advertisement
Table of Contents
Troubleshooting
