Configuring And Troubleshooting Line Card Interface Cards; Configuration Parameters - Cisco ASR 9000 Series Installation Manual
Aggregation services router ethernet line card
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Configuring and Troubleshooting Line Card Interface Cards
•
Step 4
If an error message displays on the console terminal during the line card initialization, see the
appropriate reference publication for error message definitions.
If you experience other problems that you cannot solve, contact a Cisco service representative for
assistance.
Note
Configuring and Troubleshooting Line Card Interface Cards
After the person who installed the hardware verifies that the new line card is installed correctly by
examining the LEDs, the network administrator can configure the new interface. The following sections
provide information on configuring and troubleshooting the line cards:
•
•
•
•
•
•
Configuration Parameters
Table 3-3
enabled on a Gigabit Ethernet or 10-Gigabit Ethernet line card. See Cisco IOS XR software
documentation for complete information about these parameters.
Table 3-3
Parameter
Flow control
MTU
MAC address
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
3-4
If the Card Status LED still does not go on, halt the installation. Contact a service representative to
report the faulty equipment and obtain further instructions.
If you perform online insertion or removal of the SFP or XFP module without shutting down the
interface, a warning message is displayed on the console device.
Configuration Parameters, page 3-4
Line Card Interface Address, page 3-5
Using Configuration Commands, page 3-5
Basic Line Card Configuration, page 3-5
Verifying the Transceiver Modules, page 3-6
Advanced Line Card Troubleshooting, page 3-9
lists the default interface configuration parameters that are present when an interface is
Line Card Configuration Default Values
Configuration File Entry
flow-control
mtu
mac address
Chapter 3
Verifying and Troubleshooting the Line Card Installation
Default Value
egress on
ingress off
1514 bytes for normal frames
1518 bytes for IEEE 802.1Q tagged frames
1522 bytes for Q-in-Q frames
Hardware burned-in address (BIA)
Advertisement
Table of Contents
Troubleshooting
