Removing A Line Card - Cisco ASR 9000 Series Installation Manual
Aggregation services router ethernet line card
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Removing and Installing a Line Card
Removing a Line Card
If you are replacing a failed line card, remove the existing line card first, then install the new line card
in the same slot. To remove a line card, use
Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 1
Disconnect and remove all interface cables from the ports; note the current connections of the cables to
Step 2
the ports on the line card.
Detach the line card cable-management bracket from the line card.
Step 3
Use a screwdriver to loosen the captive screw at each end of the line card front panel.
Step 4
Figure 2-1
a
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
2-6
Removing a Line Card—Cisco ASR 9010 Router Shown
Loosen the captive screws
Chapter 2
Installing Line Cards in the Cisco ASR 9000 Series Router
Figure 2-1
or
Figure 2-2
b
Pivot the ejector levers to
unseat the card from the
backplane connector
as a reference and follow these steps:
c
Slide the card out of the
chassis
Advertisement
Table of Contents
Troubleshooting
