Table of Contents
Advertisement
Installation Warning Statements
• The installation site altitude must be no higher than 10,000 feet.
Installation Warning Statements
This section includes the installation warning statements. Translations of these warning statements appear in
the Regulatory Compliance and Safety Information for Cisco Catalyst Industrial Router 8140 Heavy Duty
Series Router documents on Cisco.com, at:
https://www.cisco.com/c/en/us/support/routers/catalyst-ir8100-heavy-duty-series-routers/series.html
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended
ambient temperature of 158°F (70°C). Statement 1047
Warning
To prevent airflow restriction, allow clearance around the router of 6" on vertical sides and 12" above and
below.
Installing and Removing Modules
This section provides general module installation steps (for the offline case), and refers to additional
documentation for detailed information.
Tools and Materials You Supply
You must provide the following tool to install and remove modules:
• 10mm socket driver
Supported Modules
The following table shows the Universal Interface Modules (UIMs) supported on IR8140H. For supported
antennas of each module, see
Cisco Catalyst IR8140 Heavy Duty Series Router Hardware Installation Guide
44
Antenna Selection and Installation, on page
Installing Universal Interface Modules (UIMs)
51.
Advertisement
Table of Contents
