Table of Contents
Advertisement
Installing the Cable-Management Bracket
Before installing the chassis in the rack, both rack-mount brackets and the cable-management bracket must be installed.
To install the cable-management bracket, complete the following steps:
Align the cable-management bracket with the two right front threaded holes in the chassis as shown in
Step 1
Thread the two M3 x 8-mm Phillips panhead screws through the bracket and into the chassis. Use a number 2 Phillips
Step 2
screwdriver to tighten the screws.
Figure 7
Location of Cable-Management Bracket
1
Rack-mount bracket
1
2
Location of cable-management bracket—rear mount
Installing the Chassis on a Workbench or Tabletop
Complete the following steps to install the Cisco uBR7225VXR router on a workbench or tabletop:
Step 1
Remove any debris and dust from the workbench or tabletop, and the surrounding area.
On the chassis, ensure that all captive screws on the network processing engine, the line cards, and each power supply
Step 2
are tightened.
Add the five rubber feet supplied with the accessory kit to the base of the chassis. Five indented circles are provided on
Step 3
the base of the chassis to indicate the location to which the rubber feet can be added.
Step 4
Place the Cisco uBR7225VXR router on the the workbench or tabletop. Ensure that there is appropriate amount of
space around the router.
2
4
3
Rack-mount bracket
3
4
Location of cable-management bracket—middle mount
Figure
7.
11
Advertisement
Table of Contents
