Table of Contents
Advertisement
Chapter 4
Configuring Settings on the Cisco Unified IP Phones
Table 4-2
Network Configuration Menu Options (continued)
Option
PC VLAN
VPN
Table 4-3
Table 4-3
IPv4 Configuration Menu Options
Option
DHCP
IP Address
OL-23091-01
Description
Allows the phone to interoperate with third-party switches
that do not support a voice VLAN. The Admin VLAN ID
option must be set before you can change this option.
Shows the virtual private network (VPN) Client state:
•
Connected
Not Connected
•
(Supported only for the Cisco Unified IP Phone 7942G,
and 7962G.)
describes the IPv4 configuration menu options.
Description
Indicates whether the phone has DHCP enabled or
disabled.
When DHCP is enabled, the DHCP server assigns the
phone anIPv4 address. When DHCP is disabled, you
manually assign an IPv4 address to the phone.
Internet Protocol version 4 (IPv4) address of the phone.
If you assign an IPv4 address with this option, you must
also assign a subnet mask and default router. See
Mask
and
Default Router 1
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
Subnet
options in this table.
Network Configuration Menu
To Change
Unlock network configuration
1.
options.
Make sure the Admin VLAN ID
2.
option is set.
Scroll to the PC VLAN option,
3.
press the Edit softkey, and then
enter a new PC VLAN setting.
4.
Press the Validate softkey and
then press the Save softkey.
Display only—Cannot configure.
To Change
Unlock network configuration
1.
options.
Scroll to the DHCP option and
2.
press the No softkey to disable
DHCP, or press the Yes softkey
to enable DHCP.
Press the Save softkey.
3.
Unlock network configuration
1.
options.
Set the DHCP option to No.
2.
Scroll to the IP Address option,
3.
press the Edit softkey, and then
enter a new IP Address.
4.
Press the Validate softkey and
then press the Save softkey.
4-9
Advertisement
Table of Contents
Troubleshooting
