Table of Contents
Advertisement
Chapter 5
Configuring Features, Templates, Services, and Users
Table 5-1
Telephony Features for the Cisco Unified IP Phone (continued)
Feature
Remote Port
Configuration
Ring setting
Ringer Volume
Control
OL-23091-01
Description
Allows the administrator to configure the speed
and duplex function of the phone Ethernet ports
remotely by using Cisco Unified CM
Administration. This enhances the performance for
large deployments with specific port settings.
If the ports are configured for Remote Port
Note
Configuration in Cisco Unified CM, the
data cannot be changed on the phone.
Identifies the ring type used for a line when a
phone has another active call.
Enables you to control the minimum
ringer-volume setting and adjust the minimum
volume level for the ringer. Individual users cannot
make the changes to the minimum ringer-volume
setting.
The parameter, Minimum Ring Volume, exists in
the Cisco Unified Communications Manager
Administration, Product Configuration window.
When a user presses the minus (–) side of the
Volume button to reduce the ringer volume in an
on-hook state, the volume decreases only to the
configured minimum volume-level setting. When
the minimum volume level is reached, no status
message appears.
After a system restart, the minimum ringer volume
resets to the minimum ringer-volume setting that is
received from the configuration file. If you
configure a new minimum volume level after the
last startup and the end user had previously set the
minimum ringer volume lower, the ringer volume
will be set to the minimum value from the
configuration file, not to the level set by the user.
This feature does not apply to handset, speaker,
and headset volumes during calls.
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
Telephony Features Available for the Cisco Unified IP Phone
Configuration Reference
To configure the parameter in the Cisco
Unified CM Administration application,
choose Device > Phone, select the appropriate
IP Phones, and scroll to the Product Specific
Configuration Layout pane (Switch Port
Remote Configuration or PC Port Remote
Configuration).
To configure the setting on multiple phones
simultaneously, configure the Remote Port
Configuration in the Enterprise Phone
Configuration (System > Enterprise Phone
Configuration).
For more information see:
Cisco Unified Communications Manager
•
Administration Guide,
Configuration.
Cisco Unified Communications Manager
•
Features and Services Guide,
Phone
Rings.
Creating Custom Phone Rings, page
•
To configure the parameter in the Cisco
Unified CM Administration application,
choose Device > Phone, select the appropriate
IP Phones, and scroll to the Product Specific
Configuration Layout pane.
Directory Number
Custom
6-2.
5-17
Advertisement
Table of Contents
Troubleshooting
