Table of Contents
Advertisement
Network Configuration
Table 7-2
Network Configuration Area Items (continued)
Item
DSCP for Call Control
DSCP for Configuration
DSCP for Services
Security Mode
Web Access Enabled
Span to PC Port
PC VLAN
Forwarding Delay
LLDP: PC Port
LLDP-MED: SW Port
LLDP Asset ID
Wireless Headset
Hookswitch Control
LLDP Power Priority
CDP: PC Port
CDP: SW Port
SSH Access Enabled
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
7-8
Description
DSCP IP classification for call control signaling.
DSCP IP classification for any phone configuration transfer.
DSCP IP classification for phone-based services.
Displays the security mode that is set for the phone.
Indicates whether web access is enabled (Yes) or disabled (No) for the phone.
Indicates whether the phone will forward packets transmitted and received on the network
port to the access port.
VLAN used to identify and remove 802.1P/Q tags from packets sent to the PC.
Indicates whether the internal switch begins forwarding packets between the PC port and
switched port on the phone when the phone becomes active.
Indicates whether Link Layer Discovery Protocol (LLDP) is enabled on the PC port.
Indicates whether Link Layer Discovery Protocol Media Endpoint Discovery
(LLDP-MED) is enabled on the switch port.
Identifies the asset ID assigned to the phone for inventory management.
Enables users to receive notifications of incoming calls and answer or end calls while
working in a wireless environment.
Advertises the phone's power priority to the switch, enabling the switch to appropriately
provide power to the phones. Settings include:
•
Unknown—default
Low
•
High
•
Critical
•
Indicates whether CDP is supported on the PC port (default is enabled).
Enable CDP on the PC port when Cisco VT Advantage/Unified Video Advantage (CVTA)
is connected to the PC port. CVTA does not work without CDP interaction with the phone.
When CDP is disabled in Cisco Unified Communications Manager, a warning is
Note
displayed, indicating that disabling CDP on the PC port prevents CVTA from
working.
The current PC and switch port CDP values display on the Settings menu.
Note
Indicates whether CDP is supported on the switch port (default is enabled).
Enable CDP on the switch port for VLAN assignment for the phone, power
•
negotiation, QoS management, and 802.1x security.
Enable CDP on the switch port when the phone is connected to a Cisco switch.
•
When CDP is disabled in Cisco Unified Communications Manager, a warning is
Note
presented, indicating that CDP should be disabled on the switch port only if the
phone is connected to a non-Cisco switch.
Note
The current PC and switch port CDP values display on the Settings menu.
Indicates whether the phone accepts or blocks the SSH connections.
Chapter 7
Monitoring the Cisco Unified IP Phones Remotely
OL-23091-01
Advertisement
Table of Contents
Troubleshooting
