Yamaha FX10X Service Manual page 68

Hide thumbs Also See for FX10X:

THROTTLE BODY SYNCHRONIZATION/

EXHAUST GAS VOLUME ADJUSTMENT (For Europe)

Adjustment steps:

• With throttle body #1 as standard, adjust throttle

After each step, rev the engine two or three times,

each time for less than a second, and check the

synchronization again.

The difference in vacuum pressure between two

throttle bodies should not exceed 1.3 kPa

7. Stop the engine and remove the measuring

EXHAUST GAS VOLUME ADJUSTMENT

(For Europe)

Be sure to set the CO density level to standard, and

then adjust the exhaust gas volume.

2. Connect a jumper lead 1 to the light green ter-

3. Turn the main switch off and set the engine stop

body #2 and #3 using the synchronizing screws

Carburetor angle driver 2:

Vacuum pressure at engine idling

25.37 ~ 28.03 kPa

(0.25 ~ 0.28 kg/cm

, 0.18 psi).

• Throttle cable free play

Refer to "THROTTLE CABLE FREE PLAY

ADJUSTMENT".

• Left lower cover

Refer to "COVERS" in CHAPTER 3.

minal (CO adjustment coupler 2), and then

ground the jumper lead.

switch to "RUN".

, 3.61~ 3.99 psi)

Show Quick Links

Chapters