Yamaha FX10X Service Manual page 222

Hide thumbs Also See for FX10X:

• Loosen the steering shaft locknuts 5.

• Adjust the steering shaft 6 by turning so that

the pivot arm point right under.

Turning the steering

shaft in direction a

Turning the steering

shaft in direction b

• Tighten the steering shaft locknuts 5.

Steering shaft locknut:

25 Nm (2.5 m · kg, 18 ft · lb)

• Adjust each angle of right and left skis by turn-

ing the tie rod respectively.

• Measure the ski toe-out.

Refer to "STEERING SYSTEM" in CHAPTER 2.

For FX10RT/FX10RTR/FX10RTRA

• Steering joint 1

• Steering joint holders 2

• Install the steering joint with the shallow cutout a

facing forward.

• Align the centerline of the steering joint with the

centerline of the steering column 3 as shown in

the illustration.

• The steering joint holders should be installed

with punch marks b facing forward.

First, tighten the bolts on the front side of the

steering joint holder, and then on the rear side.

Turning the ski in

Turning the ski in

Show Quick Links

Chapters